Photos of this item are available on request — ask via the inquiry form.
Spherical bearing hydraulic cylinder ID=90mm
- Seller
- Verified company · Holm, Germany
- Availability
- Confirmed 12 Sep 2026
- Responds
- Within 24 hours, by a person
- Ships
- EXW · parcel or forwarder · pickup possible
About this part
Surplus stock from a warehouse clearance in Holm, Germany. Original listing (German): Gelenklager Hydraulikzylinder ID=90mm
Possible match · from the OceanSphere register
Model page →Unconfirmed automatic match. The system picked this model from the listing title and manufacturer; nobody has checked it. It may describe a different model or product family. Treat the figures below as a lead, not as data for this part, and ask the seller before you order.
- Equipment
- Generic Chain Cable Chain
- Model
- Stud-Link Chain 90mm Grade R3
- Manufacturer
- Generic Chain Cable
- Chain diameter mm
- 90
- Grade
- R3
- Type
- Stud-Link Anchor Chain
- Note
- Chain cable specification
- Typical failure
- Brake lining wear or contamination can reduce holding performance, noticed as slip or excessive brake travel · Gear, bearing or shaft wear can cause noise, vibration or poor torque transmission · Hydraulic leakage or low pressure can reduce pulling performance, seen as slow or weak operation on hydraulic units · Electric motor, starter or control faults can prevent operation, seen as trips or failure to respond on electric units
- Spare parts
- Carry brake and seal service items, hydraulic hoses or fittings where applicable, control fuses/relays, lubrication consumables and maker-recommended bearings or clutch parts.
About this model
Generic Chain Cable Stud-Link Chain 90mm Grade R3 is listed as a Anchor Windlass within the Anchor & Mooring Equipment category. It is typically installed on the forecastle, aft mooring deck or other exposed deck station, connected to anchors, chain or mooring lines. Its engineering role is to handle, pay out, heave and secure anchor chain or mooring lines under controlled load. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.